Delphi NA10000-11B1 - Mobile Navigation - GPS Receiver User Manual download pdf (Page 11)

4.The ball foot should now be securely fixed on the

windshield. Slip the locking nut loosely over the ball

foot, with the flat side facing upward.

5.Making sure the short side of the socket clip is at the

top, push the socket clip onto the ball foot until it clicks.

6.Adjust the position of the socket clip so that Delphi

Mobile Navigation will be clearly visible to the driver.

7.Thread the locking nut onto the socket clip; turn

clockwise until tight.

SECTION 4: INSTALLING DELPHI

MOBILE NAVIGATION IN YOUR VEHICLE

Before installing Delphi Mobile Navigation, check whether

your vehicle is fitted with a heat-reflecting or heated

windshield. If so, you will need to purchase an external

antenna from your retailer to allow your unit to pick up

the GPS signals.

The Delphi Mobile Navigation unit can be mounted three

different ways:

1.Suction onto the windshield

2.To the dash by suction or adhesive tape

3.Screw onto the dash

Note: Alternative mounting options may be available for your vehicle make

and model. Contact your retailer or Delphi for more information.

If the unit becomes hot, it prompts you to turn down the

brightness (press and hold the “Zoom” key). If the unit

becomes too hot, the screen will go blank and voice

instructions will continue.

Suction mount to windshield

1.Choose a position on the windshield where Delphi

Mobile Navigation will be clearly visible by the driver

without obstructing the driver’s view. Mount low on

the windshield, as close to the dash as possible.

2.Thoroughly clean and dry the suction cup and the

mounting area of the windshield.

3.Hold the suction cup firmly against the windshield and

press the lever down until it snaps shut.

Warning: To avoid personal injury, follow the safety guidelines and

installation instructions provided so that Delphi Mobile Navigation does

not obstruct the view of the driver, interfere with the operation of any airbags

and safety features in the vehicle, or become airborne in the case of an acci-

dent. Do not attempt to install the Delphi Mobile Navigation unit while driving.

Caution: To avoid overheating of the unit, do not leave your Delphi

Mobile Navigation on the dash or windshield while your vehicle is

unattended, especially in strong sunlight. Do not use or handle Delphi Mobile

Navigation while it is hot. Let it cool away from heat sources before handling it.

To remove the suction cup, pull the lever up. Pull the release tab

to release the suction.

If the suction cup does not adhere, clean the mounting area of

the windshield with a cloth dampened with isopropyl alcohol. Let

the area dry, then reapply the suction cup.

Suction cup

Lever

Locking nut

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Comments to this Manuals

No comments

Delphi NA10000-11B1 - Mobile Navigation - GPS Receiver User Manual Page 11

Comments to this Manuals

Related products and manuals for Navigators Delphi NA10000-11B1 - Mobile Navigation - GPS Receiver